COLTT does not recognize UO as supporting CAPE-OPEN interfaces

[michelpons]

I am using the case described in Ticket 03. I am using COLTT build dated July 17, 2011. This build incorporates a test about presence of Microsoft .Net 3.5 on the machine at installation. Since ProSim Plus does not need .Net 3.5 I installed .NET 3.5 SP1 and the necessary updates (except KB2518864 which did not succeed). The scenario calls for starting ProSim Plus with a case file that contains only four streams, one being the inlet. I insert the UO in the flowsheet and I connect its ports (one inlet, three outlets) to streams in the flowsheet. I define the UO parameters using the Edit function. Connection of ports, edition work fine from a ProSim Plus point of view with or without COLTT enabled on the UO. When asking for the UO to validate itself I get the kind of error message that is mentioned in Ticket 03. Now with COLTT build July 17, 2011, I get a very short log file saying that the UO is not supporting CO interfaces that COLTT may logged. I uninstalled COLTT July 17, 2011 and I installed the 1.08.04 version available from SourceForge. That time I get a rather complete log file that shows COLTT is able to log what happens between the PME and the PMC. Stating that the UO is not supporting the CO interfaces seems a little bit strange then.

[michelpons]

Log file obtained with COLTT 1.08.5 July 17, 2011 build

[michelpons]

Log file obtained with COLTT 1.08.4

[michelpons]

This issue has been resolved with the fix provided.