Reported by michelpons, 12 years ago.

I am using PRO/II 9.2 alpha. I enable logging on the CPP Ideal Thermo PPM and on the TEA PPM. Then I open a new case file in PRO/II 9.2, go to Input
Thermodynamic Data, select CAPE-OPEN, then CPP Ideal Thermo PPM and its nC6nC8 PP, then I quit the view \"SimSci - Thermodynamic Data\" by accepting through OK once the System CO01 is shown. I get back in the same view through Input
Thermodynamic Data and there I select the PP C1_C2 (EOS) from TEA PPM; It makes the CO02 System within PRO/II. I quit this view and then I simply exit from PRO/II. This gives the log file attached. Look at it within the viewer. Near the end the Viewer displays \"Property Package <Anonymous> : Call to put_ComponentName while, when expanding it, it shows \"getPhaseList returns\". When looking at the log file with NotePad it is then obvious that a getPhaseList call has been logged not a put_ComponentName call.

Reported by michelpons, 13 years ago.

I am considering a scenario that involves ProSim Plus 3.1 and a UO made in VB provided by an end-user. I have installed COLTT 1.08.05 Build May 30, 2011 in the machine and I have run the simulation where the UO is logged with COLTT. The logging works apparently fine but I can't get the Viewer to open up. I get a message box titled \"COLTTViewer.exe - Erreur d'application\" and the message is \"L'application n'a pas réussi à s'initialiser correctement (0xc0000135). Cliquez sur OK pour arrêter l'application\".

Reported by michelpons, 13 years ago.

Using the same .NET Unit provided by CERE, using the same scenario in COFE and in Aspen Plus 7.2, that is drop the UO onto a flowsheet made of two streams, one defined, one undefined, then connect stream 1 to inlet port and stream 3 to outlet port, then exit, I get log files which are not readable by Viewer. Viewer says there is a problem reading both files and the window remains completely blank.