Reported by michelpons, 13 years ago.

I am considering a scenario that involves ProSim Plus 3.1 and a UO made in VB provided by an end-user. I have installed COLTT 1.08.05 Build May 30, 2011 in the machine and I have run the simulation where the UO is logged with COLTT. The logging works apparently fine but I can't get the Viewer to open up. I get a message box titled \"COLTTViewer.exe - Erreur d'application\" and the message is \"L'application n'a pas réussi à s'initialiser correctement (0xc0000135). Cliquez sur OK pour arrêter l'application\".

Reported by michelpons, 12 years ago.

I am using PRO/II 9.2 alpha. I enable logging on the CPP Ideal Thermo PPM and on the TEA PPM. Then I open a new case file in PRO/II 9.2, go to Input
Thermodynamic Data, select CAPE-OPEN, then CPP Ideal Thermo PPM and its nC6nC8 PP, then I quit the view \"SimSci - Thermodynamic Data\" by accepting through OK once the System CO01 is shown. I get back in the same view through Input
Thermodynamic Data and there I select the PP C1_C2 (EOS) from TEA PPM; It makes the CO02 System within PRO/II. I quit this view and then I simply exit from PRO/II. This gives the log file attached. Look at it within the viewer. Near the end the Viewer displays \"Property Package <Anonymous> : Call to put_ComponentName while, when expanding it, it shows \"getPhaseList returns\". When looking at the log file with NotePad it is then obvious that a getPhaseList call has been logged not a put_ComponentName call.

Reported by michelpons, 14 years ago.

The attached log file was obtained with the scenario of ticket #33 and with COLTT development version 1.08.5 Build June 30, 2010. When opening the file a message box appears stating \"Some problem reading the file\".