Ticket #43 (closed defect: fixed)

Opened 15 years ago

Last modified 13 years ago

PME aborts in get_Reports

Reported by: michelpons Owned by: Michael Halloran
Priority: major Milestone: 2.0 No dependency/Viewer/New installer
Component: COLoggers Version: Development
Keywords: Cc: michaelhalloran

Description

I am using a UO built by IFP within COFE 1.15. The UO is a 3-phase separator. When the UO is not logged, the calculation goes to its end but COFE displays warnings about properties not set. So I enabled COLTT on the UO and reran the case. With COLTT enabled on the UO, I can drop the UO in the flowsheet, I can connect the inlet port and the three outlet ports to streams, but COFE aborts when I double-click on the icon representing the UO. The Edit method of the UO is not implemented and normally the generic UO interface from COFE should have appeared so that I may give values to the UO parameters.

The attached COLTT log shows that the logging stops in get_Reports. I attach also the COFE document from where I start. The installer for the UO is too large to be attached and will be delivered through a file server.

Attachments

MyFlowsheet1.fsd​ (53.9 KB) - added by michelpons 15 years ago.
COFE document used as starting point
cofe_111809_170416.log​ (24.7 KB) - added by michelpons 15 years ago.
COLTT log file obtained
WithCOULIS.olg​ (240.8 KB) - added by michelpons 15 years ago.
Log file obtained with COULIS
cofe_060611_122832.log​ (32.4 KB) - added by michepons 14 years ago.
Log file obtained with COLTT 1.08.05 Build May 30, 2011

Change History

Changed 15 years ago by michelpons

COFE document used as starting point

Changed 15 years ago by michelpons

COLTT log file obtained

comment:1 Changed 15 years ago by michelpons

I have made the same run but with COULIS and indeed the issue may be with the reports. See the attachment obtained with COULIS.

Changed 15 years ago by michelpons

Log file obtained with COULIS

comment:2 Changed 14 years ago by michelpons

  • Status changed from new to closed
  • Version changed from 1.08.4 to Development
  • Resolution set to fixed

I have re-tested the scenario using COLTT 1.08.05 Build May 30, 2011. The COFE version used is the latest one though. Still I think the test is valid since the issue was with get_reports. I have not experienced any crash this time. get_reports raises an exception which is managed by COLTT properly. I attach the log file obtained today and I consider the issue as fixed.

Changed 14 years ago by michepons

Log file obtained with COLTT 1.08.05 Build May 30, 2011

comment:3 Changed 13 years ago by michelpons

  • Milestone set to 1.08.05
Note: See TracTickets for help on using tickets.