Custom Query (122 matches)
Results (58 - 60 of 122)
| Ticket | Resolution | Summary | Owner | Reporter |
|---|---|---|---|---|
| #80 | worksforme | Viewer fails to initialize | michaelhalloran | michelpons |
| Description |
I am considering a scenario that involves ProSim Plus 3.1 and a UO made in VB provided by an end-user. I have installed COLTT 1.08.05 Build May 30, 2011 in the machine and I have run the simulation where the UO is logged with COLTT. The logging works apparently fine but I can't get the Viewer to open up. I get a message box titled \"COLTTViewer.exe - Erreur d'application\" and the message is \"L'application n'a pas réussi à s'initialiser correctement (0xc0000135). Cliquez sur OK pour arrêter l'application\". |
|||
| #79 | fixed | Log file does not load properly | Michael Halloran | michelpons |
| Description |
I am using A+ v7.1 and a FORTRAN UO Mixer. While the run goes rather well (the UO is not found in mass balance by A+ though) with COLTT (May 30, 2011 build) enabled on the FORTRAN UO Mixer, the log file obtained does not load properly in the Viewer. |
|||
| #78 | fixed | When UO logged no connection on ports | michaelhalloran | michelpons |
| Description |
The PME used is Aspen Plus 7.2. The PMC used is a UO in .NET made by DTU/CERE. The scenario is to start from a Aspen Plus case where two streams are defined, one to serve as input, the other as output. Without COLTT enabled on the UO, it is possible to connect the defined stream to the UO inlet and to connect the other stream to the outlet port. The UO is then considered as valid and calculation may be launched. Calculation ends up with an error: the material flow in the outlet stream is way too large compared to the material flow in the inlet stream. That calls for a look with COLTT. When COLTT is enabled on the UO, it is impossible to connect streams to ports, so it is impossible to reach the point where the calculation is made. |
|||