Custom Query (122 matches)
Results (46 - 48 of 122)
Ticket | Resolution | Summary | Owner | Reporter |
---|---|---|---|---|
#77 | fixed | Viewer can't read log files | michaelhalloran | michelpons |
Description |
Using the same .NET Unit provided by CERE, using the same scenario in COFE and in Aspen Plus 7.2, that is drop the UO onto a flowsheet made of two streams, one defined, one undefined, then connect stream 1 to inlet port and stream 3 to outlet port, then exit, I get log files which are not readable by Viewer. Viewer says there is a problem reading both files and the window remains completely blank. |
|||
#78 | fixed | When UO logged no connection on ports | michaelhalloran | michelpons |
Description |
The PME used is Aspen Plus 7.2. The PMC used is a UO in .NET made by DTU/CERE. The scenario is to start from a Aspen Plus case where two streams are defined, one to serve as input, the other as output. Without COLTT enabled on the UO, it is possible to connect the defined stream to the UO inlet and to connect the other stream to the outlet port. The UO is then considered as valid and calculation may be launched. Calculation ends up with an error: the material flow in the outlet stream is way too large compared to the material flow in the inlet stream. That calls for a look with COLTT. When COLTT is enabled on the UO, it is impossible to connect streams to ports, so it is impossible to reach the point where the calculation is made. |
|||
#79 | fixed | Log file does not load properly | Michael Halloran | michelpons |
Description |
I am using A+ v7.1 and a FORTRAN UO Mixer. While the run goes rather well (the UO is not found in mass balance by A+ though) with COLTT (May 30, 2011 build) enabled on the FORTRAN UO Mixer, the log file obtained does not load properly in the Viewer. |